Showing results for 
Search instead for 
Did you mean: 

The 1410 series root bridge and non-root bridges have Intermittent connectivity and event logs show the "Interface Dot11Radio0, Deauthenticating Station Reason: Previous authentication no longer valid" error message


Core Issue

Bridge tolerance which is CCA was configured lower to the noise, thus causing connectivity problems among the root and non-root bridge.


If there is a flapping issue among the root and non-root bridges, it is necessary to check the Cisco Clean Access (CCA) and distance settings. The CCA is the point at which the bridge considers signal noise versus good signal, which is the tolerance of that bridge as to the noise.  If noise is more than the CCA, the bridges have connectivity problems. The default value as per Cisco is  61dBm and if you run an increased value of noise in the environment, that possible leads to problem. If the noise evaluates to be  62dBm on the Root and  63dBm on the Non-Root, then under the network interfaces on both devices, you need to configure the CCA to 75 and distance to 1.

Refer to Intermittent Connectivity Issues in Wireless Bridges for more information on the Intermittent issue.

Problem Type

Intermittent connectivity - flapping

Error message



Access point

CreatePlease to create content
Content for Community-Ad

Cisco COVID-19 Survey