Installation of the Aironet Client Utility (ACU) has failed.
If your attempt to install ACU fails, follow these steps:
Close any Windows programs that are running.
Select Start > Run, and enter the path to the installed ACU files (the default location is C:\Program Files\Cisco Aironet\setup.exe), and click OK. The Welcome screen for the Aironet Client Utility setup maintenance program appears.
Select Repair and click Next. The Setup Complete screen appears.
If your computer needs to be rebooted, select Yes, I want to restart my computer now or No, I will restart my computer later. Note: If you are prompted to reboot your computer, Cisco recommends that you select the Yes, I want to restart my computer now option.
Click Finish. The repair is complete. All of the selections you made during the previous installation are maintained.
WLAN adapters (wireless card) / ACU (Aironet Client Utility)
Unable to configure more than one snmp trap receiver with same snmp community string in AireOS WLC. AireOS WLC(Cisco Controller) >config snmp trapreceiver create ABCDEFGH 10.10.10.11SNMP Trap Receiver added!(Cisco Controller) >config snmp trapr...
Hi WLC C9800 need to add several vlans. I am not sure Source-interface vlan is required for dhcp function or something else. Please see the below picture. If we do not configure it, what would happen? Thank you
I'm new to the networks.I need to set up a network to connect my PC to its data acquisition device (usually connected via LAN, static IP).PC is 200 m far from daq device. Between daq device and PC there are several metal structures. I have already tried w...
Anyone running a 2504 WLC, with code level 184.108.40.206? On mine, the graphic for the front of the device on the Monitor --> summary page is missing. It's always been there in older code versions. I looked in the page source and found tha...
We have two Cisco 5508 WLC and SSO is enabled. If i follow the below steps, will it erase the configuration of both WLC's. Please confirm. Thank youlogin to WLC GUI with valid username and password.Go to Command > Reset to Factory D...