Cisco IOS Software Release 12.4(3)c runs on the 2811 Integrated Services Router (ISR), and it does not support the Wireless LAN Controller Module (WLCM).
The Interface WLAN-Controller 1/0 line protocol can also fail.
Upgrade the Cisco IOS software on the 2811 ISR to Cisco IOS Software Release 12.4(6)T. This enables the WLCM to be recognized on the ISR. As a temporary solution turn off the keepalive on the controller interface.
Cisco IOS Software Release 12.4(6)T, which is also called Cisco IOS Software Release 12.4(3rd release)T, is not Cisco IOS Software Release 12.4(3)T. These Cisco IOS software releases can also be used:
Cisco IOS Software Release 12.4(2)XA1
Cisco IOS Software Release 12.4(3rd release)T or later
The WLCM allows small and medium-sized businesses (SMBs) and enterprise branch offices to cost-effectively deploy and manage secure wireless LANs (WLANs). The module provides unparalleled security, mobility, and ease of use for business-critical WLANs and delivers the most secure enterprise-class wireless system available. As a Cisco ISR module, it delivers:
centralized security policies
wireless intrusion prevention system (IPS) capabilities
Quality of Service (QoS)
Layer 3 fast secure roaming for WLANs
The WLCM manages up to six Cisco Aironet lightweight access points and is supported on these routers:
I have a WLC 3504 at a central location and six sites that use it, including the site containing the controller. The controller has an Internet breakout on port 2 and LAN access on port 1. I am looking at implementing Flexconnect and have been through the...
Facing this issue, few APs were not working so rebooted the WLC, after reboot no APs were showing, set the Controller to factory defaults, configured as per the cisco guide but no hopepresent situation:WLC 4404, APs:LAP1242AG-E-k9Acess Points are on ...
HI Everyone, I looked at the interface details and noticed that all dynamic-interfaces have the same MAC address. And it is basically the same as the MAC address of the management interface. My WLC is 5508, and I want to know how the Cisco WLC assign...
We are implementing a VLAN in a confined environment which combines both wired and wireless connections. We currently have multiple Full HD (1920x1200) video cameras, each streaming >3.3Gbps, so we are using 10Gig switch over RJ45. The video is multica...