It is problematic to use Wireless LAN Solution Engine (WLSE) release 2.11 and Cisco IOS version 12.3(7)JA on the Cisco Access Points (APs)because WLSE release 2.11 does not support Cisco IOS version 12.3(7)JA for AP. This is why it can be difficult to manage the APs with WLSE. For more information on WLSE, refer to Upgrading CiscoWorks WLSE and WLSE Express Software, 2.11.
Note: WLSE release 2.12 supports Cisco IOS version 12.3(7)JA.
Note: WLSE release 2.13 will support Cisco IOS version 12.3(8)JA.
I know what it does, it uses the IP address of the dynamic interface associated with the WLAN as the source instead of the management interface, but due to my lack of experience in the wireless field, I was wondering why would you use that feature? I...
I have a used Cisco 5508 wireless controller. How do I see what boot image the controller is running on the graphical interface? I was on the page but I'm so new to this, I can't find the page again.Thank you.
So I've been trying to setup a 9800-CL a few times on my intel nuc here at home (only one NIC). I'm got it up and running on esxi 6.7 but I can't create a trustpoint and for this reason of course my access point can't connect. I have had nothing but probl...
Hello all,I'm a complete newbie with Cisco Prime. One of the customers I work with has it and I'm trying to help implement some wireless changes. I have imported two maps and placed the AP's on the maps at Main Menu > Maps > Site Maps (New!) > Bu...