The signal in the wireless network may be weak or fluctuating due to the following reasons: Firmware and driver problems Software configuration problems RF impairments, including antenna and cable problems
Problems with the radio frequency (RF) communications between Cisco Aironet WLAN components can usually be traced to three root causes: Firmware and driver problems Software configuration problems RF impairments, including antenna and cable problems For more information on troubleshooting this problem, refer to the Troubleshooting Problems Affecting Radio Frequency Communication document.
The signal is weak or fluctuating
WLAN adapters (wireless card) / ACU (Aironet Client Utility)
We can't configure/manage/monitor our C9800-L-F-K9 16.12.04a with an iPhone or iPad. (iOS Version 13 or 14) and the web management page of the controller.(Access local via wireless - no cloud configuration)With browser (Safari, Chrome, Firefox on iphone o...
We have a dilemma. We have a site that has 34 1532E and I AP's that are NOT budgeted to be replaced this year. This year we are replacing the old 5508 WLC because vulnerability patches ended this year. We bought the 9800 controller replacements and soon r...
My organization inherited a 9 slot 6500 chassis from another department. Included with this chassis was a WISM2, The 720 supervisory engine, and 48 port switch blades. We are currently using just those 3 blades to provide our organization with Wireless co...
hoping someone can point me to a resource... We have a Cisco c1111-4plteea with GPS enabled, but it is flooding the server with coordinates, reporting over 200 times per minute.. Is there a way to throttle or control how often the coordina...
We aquired a 840 and 860 Webex Wifi Phone recently to test. We have an internal WiFi that is secured via certificates from ISE.From the very start we had big issues with the two phones - our Windows PCs run just fine on the WiFi, but the phones lose conne...