cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Unable to establish a point-to-point connection between the Cisco Aironet 1400 Series Wireless Bridges

821
Views
0
Helpful
0
Comments

Core Issue

The root and non-root bridges cannot associate with each other. The status of the non-root bridge radio is RESET, and the protocol is DOWN.

Resolution

This issue is documented in Cisco bug ID CSCsb08590.

As a workaround, perform these steps:

  1. Download Cisco IOS  12.3(7)JA or later from Cisco.com as a "recovery image."

  2. Issue the archive command or use the GUI in order to download the "recovery image" into the BR1410 Flash.

  3. Issue a command similar to the one listed in order to recover the radio:

    bridge#dot11 dot11Radio 0 recovery-fw flash:c1410-k9w7-mx.123-7.JA/6501.img

    Note: Issue the dir Command-Line Interface (CLI) command in order to verify the actual filenames.

  4. Issue the archive command or use the GUI in order to reload the desired code into the bridge.

    Note: There is the option to stay on Cisco IOS 12.3(7)JA rather than fall back to version 12.3(4)JA, or to apply version 12.3(4)JA.

Refer to Mounting and Alignment Overview for more information on bridge mounting and antenna alignment.

Refer to Cisco Aironet 1400 Series Wireless Bridge Ordering Guide for more information on the Cisco Aironet 1400 Series Wireless Bridge.

Refer to Configure the Bridge for the First Time for more information on how to configure the bridges.

Refer to Cisco Aironet 1400 Series Wireless Bridge 28-dBi Dish Antenna for more information.

Problem Type

No connectivity

Products

Bridge

BR 1400

Role in Radio network

Root bridge

Non Root Bridge

Topology

Point to point network

Wireless Stages

Unauthenticated and Unassociated

CreatePlease to create content
Content for Community-Ad

Cisco COVID-19 Survey