Facing an error while adding the license files to WCS. The WCS is migrating to the Cisco Prime Network Control System (NCS).
Migrating Cisco WCS Licenses to Cisco Prime NCS Licenses
The Cisco Prime Network Control System uses a single-tier license model. When Cisco WCS BASE or WCS PLUSlicenses are being migrated, licenses will be mapped to the new Cisco Prime NCS single-tier model, as shown in Figure 1. Customers are able to migrate their existing WCS licenses by purchasing the migration SKU (L‑WCS-NCS1-M-K9) as also indicated in Figure:
The Cisco Prime Network Control System uses a single-tier license model. When Cisco WCS BASE or WCS PLUS licenses are being migrated, licenses will be mapped to the new Cisco Prime NCS single-tier model. Customers are able to migrate your existing WCS licenses by purchasing the migration SKU (L-WCS-NCS1-M-K9).
If you are moving to a virtual (VMWare) environment, you only need to order SKU L-WCS-NCS1-M-K9. If you are running physical servers, you will require both of these SKUs: L-WCS-NCS1-M-K9 and PRIME-NCS-APL-K9. If you want to increase capacity, then you will also need to add this SKU: L-NCS-1.0-ADD-K9, with a quantity of however many users you would like to add. For example, if you would like to add 100 users, you will need to add SKU L-NCS-1.0-ADD-K9 at a quantity of 100.
Please apply the L-WCS-NCS1-M-K9 license first, before adding the licenses migrated from your WCS installation; the licenses migrated from WCS are generated as "ADD" licenses and they can't be applied before the L-WCS-NCS1-M-K9 is applied.
Just wondering what the best practice is on using DHCP proxy mode vs DHCP bridging mode for roaming clients (L2 / L3 roam)? Does the DHCP proxy feature add significant time to the DHCP handshake and cause roaming clients to lose packets when they go ...
Hi all, I am having issues setting up a few Aironet 1262s (AIR-LAP1262N-E-K9) They are powered from a 3560 PoE-8 (only one at a time) and they power up...The power comes on and the light flashes green for bit (I assume booting)The light then is ...
Hi all, I am using WLC 3504 and i have created a open ssid that require web auth. I have also enabled a lobby admin account on my WLC to create accounts for guests to connect to this ssid. The default ip of the interface of this ssid is 220.127.116.11. For ...
Hello everyone,I am a new customer of Cisco Access Point AIR-AP2802E-E-K9C. I don't have much experience with this class of hardware Cisco. Could someone help me, how to configure this AP? I have experience with switches and routers. I would like, to this...
Dear all, I cannot reimage AP1852i through rommon mode .I tried below commands but it doesn't work. When it boot, it will load the old image (the old image has an issue so I cannot access to controller cli or webui)tftpboot AIR-AP1850-K9-8-5-151...