What is the maximum number of APs supported on the 4402 and 4404 wireless LAN controllers (WLCs)?
The limitation on the number of supported access points is based on the hardware that you have. The 4402 WLC with two gigabit Ethernet ports comes in configurations that support 12, 25, and 50 Light Weight Access Points (LAPs). The 4404 WLC with four gigabit Ethernet ports supports 100 LAPs.
Note: Mesh access points are also available in both indoor and outdoor deployments. For more information on number of access points (including mesh APs) supported on each controller model, refer to Table 8-3 Mesh Access Points Supported by Controller Model in the Controlling Mesh Access Point section of the Wireless Lan Controller Configuration Guide 6.0.
You cannot increase the number of supported access points with only the configuration of the access point.
Hi Guest ssid, wlan, and policy are configured based on cisco document attached link. it uses internal web server. Client PC can get correct ip address from the c9800, but auth web page does not show up. I notice I did not have chance to setup password du...
Hello,I temporarily set up WiFi for users in a remote location. I'm using 2702 APs and running WLC 8.5.The uplink we have is not great and has a FUP, so I'd like to limit unnecessary data usage. Nowadays, mobile phone hotspots can use Vendor Specific Info...
Dear allCan i update NBAR2 Advanced Protocol Pack WLC to version 38 ?I have WLC 5520 version 8.2 . I try to download NBAR2 on website cisco but it only have download version 24.I would like to download version 38 it for suuport zoom meetingthank you
Hi, In c9800 wlc, looks like there are two sites for configuring dhcp relay. One is at Vlan SVI---> Advanced, second is at Policy ----> Advanced ----> DHCP. What is difference between the two location for configuring dhcp relay? I think the final...
Hi i have routed access layer design as im running L3 to the access and OSPF as IGP ( Core - Distribution - Access ) thw WLC 3504 connected to the Core the the APs 1800 connected to the Access Sw each with different subnetsi could register the A...