The installer software needs to have Internet Explorer as default browser to properly check the needed dependencies, and download all components. If you are using another browser, set temporarily to IE, to complete the installation. After it is done, you can move back the default browser to the previous setting
For errors containing "Store metadata "AppType" is not valid." in the log details, try this:
In control panel --> Regional and language settings --> Regional Options tab, change the language to english(australia) and apply the change, then change it back to English(United States) and apply. Reboot PC, and try again.
(this is for a wrong registry entry, fixed with the above procedure)
The installer is trying to download components, why?
The application neeeds .Net 3.5, and it will try to download it if needed
Hi, We have a new WLC 9800 in our network, and I'm required to install the CA-Server Certs on the controller to have secure connection to the WLC GUI through the browser, how do I perfom this task? does it work like ISE and Stealthwatch in a similar ...
Hi Team, We have recently upgraded the wlc (5520)to new code 8.10.130.Post the upgrade users connecting to local mode AP's(3700) are not getting ip address.After reloading the AP users are getting the ip address. Regards,Anjana
Hello, I have a RV345 Cisco router and recently purchased a C9105 WAP. I've assigned a static IP address to the WAP (192.168.1.125) and can ping the WAP, however it is still not 'discoverable' using FindIT, nor can I direct GUI access via 192.1...