I need to restrict certain wireless capabilities due to compliance reasons. These include:
Limit power transmission
The APs (AIR-CAP2702I-E-K9) are being controlled by the WLC. As far as I can see, I am only able to change the Tx Power Level on a per-AP basis (Wireless>All APs>AP), but ideally I would like to this this from a central location.
I was able to fix the channel by creating an RF Profile and selecting the required channel under the DCA Channel list (Wireless>RF Profiles>Profile>RRM). I made sure to create a 802.11b/g profile and assigned it to the AP group under "RF Profile". I set the 802.11a profile to "none", in the hope that it will disable 5GHz, but this is not the case. I even set the Data Rates under the RF Profile to the following:
I left the MCS setting unchanged (All selected).
When checking the connected clients, I can see an iPhone is connected to one of the APs with 802.11an (5GHz) and checking the radios of all APs, I see that all APs in the group are still broadcasting on 5GHz channels?!
So my main question is:
How can I ensure that only the 2.4GHz spectrum is used and that 802.11b is not enabled? I am unable to use global settings, as we have other production APs that do not need to conform to the given requirements.
Hi everyone i have AIR-CAP3502I-E-K9 as stand alone connected to my cisco isr and the maximum speed I can achieve is about 47mbps on 802.11n . I tried setting different modulation and channel width, inreasing antenna power etc. and nothing! belo...
Greetings fellows, Kindly assist about the configuration to add Cisco AIR-AP1832i-K9 to a Cisco WS-C3650-48PS.I have been trying to google the concept and configuration steps but I have found a clearly document step by step configuration that I can f...
I am having trouble with ME failover. It should assume the shared IP and allow management, correct? All WAP's are showing ME Capable. Whether I manually set one as preferred master which I think is an option? Or if I let it try to ...