WLCCA Feature Requests

[Javier Contreras]

WLC Config Analyzer Feature Tracking

Updated: 22-April-2014

Converged Access support

ID	To do item/feature request	ETA	Status
1	NGWC: Add multicast/multicast config detection AI: Seema to add more details on detection logic	3.4
2	NGWC: Detect missing virtual IP address in web auth configuration AI: Madhu to provide more details	3.4

New Checks

ID	To do item/feature request	ETA	Status
1	Report error if more than one interface has native vlan 0, and using non-lag scenario. This is unsupported scenario for IPv6 clients	3.3

New Features

ID	To do item/feature request	ETA	Status
1	Add parsing and config comparison between controllers for: Clean Air Solution Setting Air Quality Settings Interference Device Settings CleanAir ED-RRM Settings	3.4
2	Flexconnect group support Add parsing and config display for flex connect groups	3.3
3	Compare vlan mappings for APs on same flex connect group	3.4
4	Client SNR/RSSI distribution graph	3.2	Implemented  SNR in beta 3.2.3
5	BYOD Audit	3.4	Check policies under discussion/development
6	Best Practices 2.0 Implementation	3.2	Partially implemented in 3.2.2

[Cliff Campbell]

I have two feature requests:

1. 8.0 support (obviously).  Getting "parsign" (spelling error; feature request 1a? :D) errors for QinQ configuration and capwap prefer mode

2. CCA recommends AVC on a vWLC which isn't supported.  Maybe a check for this?