Wireless LAN Solution Engine (WLSE) fails to reach the Security Keys Setup stage while Access Control Server (ACS)/CiscoSecure is the RADIUS server. This is noticed regardless of the WLSE version and is specific to ACS CiscoSecure 3.3.3 and later.
This issue is documented in Cisco bug ID CSCsb47726.
There is a pointed patch available for ACS 3.3.3 (both ACS software and solution engine).
To install the patch on the software ACS, perform these steps:
Hello! Customer is replacing a 2504 with two 3504 in HA. Also replacing APs 1702i with 2802i. For faster migration, software version was kept the same, 220.127.116.114's configuration was uploaded via GUI and converted using TAC's WLC Config Converter a...
I'm installing a 1562E with an ANT2513 however I cannot find how to change the AP to use 2.4GHz on ports 1 and 2 then 5GHz on ports 3 and 4 which appears to be a requirement for this antenna. Running 8.5.161 code currently.
I have some Cisco Aironet 1700 APs (AIR-CAP1702i-E-K9) I'm trying to add to my LAN, however I'm unable to connect and configure them by every method I have tried. I can see the APs connect to the main switch and are assigned an IP address via DHCP. H...
Hi looking for a little advice, what exactly is 'Signal Quality' shown in the attached image (taken from Cisco controller)?Is it the same as RSSI (dBm) or SNR? And what do the values on the image tell me about all three user's Wi-Fi connections? Is 0dB go...