This topic is a chance to discuss more about Cisco Wireless LAN Controller (WLC) deployment, its best practices and troubleshooting tips. This session provides to its participants a better understanding of the different WLC configuration options and it enhances the wireless troubleshooting skills of the participants. Join the discussion and learn more about the best WLC operation practices with direct recommendations from the Cisco Technical Assistance Center (TAC) engineers.
Ask questions from Monday 5th to Friday 16th of March, 2018
Jhosbell Verdesca currently works as Cisco Support Engineer at the Cisco TAC Mexico on the Wireless team, providing support to customers all around the globe since May 2015. Before then, he worked for 3 years for a Cisco Gold Partner at Caracas, Venezuela implementing and supporting solutions in the Routing, Switching and Security areas. Jhosbell holds a Bachelor’s Degree in Telecommunications Engineering from the Universidad Catolica Andres Bello (UCAB) - Caracas, Venezuela. He also holds CCIE Routing and Switching (#58023) and CCNA Security certifications.
Ricardo Garcia Duarte has been a team lead for over 3 years for the Cisco Mexico TAC Wireless team, he provides support to customers and partners across the world since January of 2015. Before joining Cisco, he worked for different service providers such as Verizon and Dell on Routing & Switching networking. Ricardo holds a Bachelor’s Degree in Information Technology Engineering from the Universidad Tecnologica de Bahia De Banderas (UTBB) from Nayarit, Mexico. He holds an ITIL Expert and CCNA Wireless certifications, also he’s a Technical Content Engineer for Cisco documentation.
Jhosbell & Ricardo might not be able to answer each question due to the volume expected during this event. Remember that you can continue the conversation on the Contact Center Community
We are pleased to announce the immediate availability of the IOS-XE release 17.3.1 for the Catalyst Wireless Controllers. The new code is now posted on the CCO and can be found at this link:
Got a 1572 AP plugged in getting ready to finish configuring it. It discovered the WLC fine and I changed the AP mode from Bridge to Local so it rebooted. That's where it has gotten stuck. I get as far as the below output and it hasn't changed for over an...
Hello,I've 2 Physical WLC 9800 in SSO, and I'd like to know if it's possible to monitor the Management AP Interface to force a Failover if it's not reachable.I physically shutted the Interface that carry the AP Management IP to see what's happening,...
Buen día, alguien tiene información sobre si se puede crear distintos tipos de acceso a la plataforma CMX??? Necesito que distintas personas puedan entrar al CMX, pero que cada uno de ellos solamente pueda ver la información de un solo edificio. O s...
Hello, I have a pair of 5508 WLC setup in HA mode. What is the best way to change the IP addresses of the management and redundancy management interfaces on BOTH 5508 WLC? I also need to change IP addresses of all the WAPs too. Are ...