To participate in this event, please use the button to ask your questions
This topic is a chance to discuss more about the best practices, considerations and proved guidelines to configure, monitor and troubleshoot 802.11 wireless services under Meraki Cloud-Based architecture. The session focuses in the following topics:
Configuration topics include SSID definition, authentication types, client IP assignments, service distributing, availability, firewall, traffic shaping, and radio settings.
Monitoring topics cover the understanding of the Access Points status information, client details and RF status.
Troubleshooting tools provided by the Meraki Dashboard such as Wireless Health and Packet Captures.
Ask questions from Monday 6 to May 17th, 2019
Edgar Monroy is a Support Engineer for Cisco Meraki Products, he covers MX, MS, MR, MV and SM. Before joining Meraki’s team he worked as a Cisco Customer Support Engineer for Cisco’s TAC for 4 years. He specializes in 802.11 technology and he has experience in the entire Cisco Wireless Portfolio, including CUWN, Mobility Express, Prime Infrastructure, MSE, CMX and Meraki MR Products. Edgar holds a Bachelor’s Degree in Electronics Engineering from the UDFJC University in Colombia. He holds a CWNA and a CCNP R&S certification.
Hello,I know that an AP i going always to see a client better. According to Jerome Harry is about 6dBm difference. I have taken the reading from the controller and I struggle to make out what is what, since the values are the other way round. The client s...
Hi All, i have a scenario where the WAP 3800 is not joining the WLC available locally within the building but goes and joins the WLC available over the WAN link on HQ Office. when i check the LAP i see it sending the discover request and g...
Hi Tech guys, i have 3 5520 WLC in different Locations,WLC are in Standalone deployement. Building 1 ==== WLC 5520 (20 Access point)Building 2=====WLC 5520 (20 Access point)Building 3=====WLC 5520 (20 Access point) i ...
Dears, I have Cisco AIR-CAP2702i-E-K9 access point and it was perfectly working till yesterday through PoE without any issues. suddenly it's stopped and when I checked with console cable there is no response from AP and the LED is Off.Just now I...
I've got an old Cisco 891 with two SSIDs configured. Both SSIDs are assigned to Dot11Radio0 and Dot11Radio1 Right now, it looks like Dot11Radio0 is on one channel: channel 2462and Dot11Radio1 is on a different channel:channel 5240 I'm ...