cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
2793
Views
5
Helpful
0
Comments
TCC_2
Advocate
Advocate

Core Issue

This message does not imply an error, but is just a warning. If you select No when prompted to save, the configuration is not saved. On the Cisco Access Points (APs), configuration files are not saved on NVRAM but on Flash. This warning message implies that the buffer size is not large enough.

Resolution

The workaround for this issue is to increase the buffer size on the AP.

To specify the Non-Volatile RAM (NVRAM) simulation buffer size for a configuration file, issue the boot buffersize command using the Command Line Interface (CLI), as shown:

ap#config t
ap(config)#boot buffersize 256000

Note: The boot buffersize value used in this document is just an example. Care must be taken when selecting the value.

Problem Type

Error message

Products

Access point

Security Options

WEP key

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Quick Links