Hello Team, We have several APs with multiple SSID (autonomous setup, no
WLC). A video on demand (VoD) server is connected into the same switch
and operating on the same Vlan. Video quality from media server is
crystal clear when a laptop is connected to ...
in My Videos)Looking to design a voice over WLAN network and did not
know where to start, check out this 20 minute video which takes you
through the process. You can use this video along with the 7921/7925
deployment guide to setup a VoWLAN network.
Hi guys, Could someone please explain dhcp proxy mode "GLOBAL". I find the official guide of dhcp setup for wlcs not very detailes. Is it true that we should specify interface which should be used only when Global is set. If yes, what happe...
Hello friends. I have several AIR-AP1852I-E-K9 and AIR-AP1562E-E-K9 administered centrally in a controller which is configured in one of the AIR-AP1852I-E-K9. Specifically the AIR-AP1562E-E-K9 are attached with two AIR-ANT2547VG-N antennas connected...
Good day.We have Cisco WLC 2504 with fw ver. 22.214.171.124 that already works with few access points.We purchase new AP 1815i but it has 126.96.36.199 fw ver ( newer than WLC ) All other APs, that we connect to WLC earler, was automaticly updated t...
- AP1 Model : WAP581-A-K9 V01 Firmware Version (Active Image): V188.8.131.52- AP2 Model : WAP581-A-K9 V01 Firmware Version (Active Image): V184.108.40.206- AP3 Model : WAP581-A-K9 V01 Firmware Version (Active Image): V220.127.116.11 Three APs are being used, and ...
Hi All,Need help in understanding RRM for 80 MHZ. We have channel width 80 MHz and because of this , we found channel overlapping. We set channel interval time with 10 minutes (default) and DCA set as automatic. But we are not seeing channel change h...