This video explains how to configure a Lightweight Access Point through CLI. It also explains how the configuration commands behave depending on the version of firmware on the Wireless LAN controller.
I'm using first time Cisco AP (AIR-CAP2602I-E-K9) pl. advice how to configure it step by step.
I'm trying by using console port(serial cable) using Putty and stuck on below-mentioned step
AP7426.ac1a.bef0#
pl. advice appreciates your prompt response.
Thanks & Regards
Getting Started
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: