Interpreting LAP LEDs - LAP1130

2142

Views

Helpful

Comments

(view in My Videos)

This short video explains how to interpret the LEDs on a 1130AG Lightweight AP.

1 Comment

Thanks Rajesh for this informative Video on 1130AG LWAPP.

You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.

Comment

Latest Contents

Can you config a AIR-LAP1262N-T-K9 as a stand alone?

Created by RafaelCDJesus53730 on 11-22-2019 12:03 PM

Hi guys, i try to configure this equippament for use wi-fi , but i dont know how change a original mode for a stand alone.any body knows how to solve this?

Packet dump from 5520 WLC

Created by MatthewRobinson5751 on 11-22-2019 08:35 AM

I'm trying to track down a problem with an 8821 phone, and getting stuck trying to capture packets on the controller. (WLC5520,software version 8.5.140.0). Lightly-edited logs below: (Cisco Controller) >debug ap packet-dump enable (Cisco Con... view more

C9800 - Local guest user

Created by toddsnyder on 11-22-2019 08:00 AM

On the old Aeronet WLC you could limit the SSID a guest could use when creating the guest account. I don't see the ability to do that now on the C9800. How can I limit which SSID a guest account can use on the new C9800 WLC platform? Tha... view more

Anchor in 8.5 and Foreign in 8.10

Created by Antonio Macia on 11-22-2019 03:33 AM

Hi, Should I expect any incompatibility issues between these you software versions running at the anchor and foreign controllers? According to other posts in this forum, the anchor and foreign can run different software versions, but is this true whe... view more

Power adaptor for 2802 access point

Created by abinaya.2.r on 11-21-2019 09:09 PM

Hi. i am ordering a 2802 access point. This AP will not connect to the POE switch. Can you help me with the part code for the external power source ? I am ordering the below in Cisco portal. Can you help with the power source AIR-AP2802I-E-K9AI... view more

CreatePlease to create content