2.4 GHz. Frequency setting.

[alikoca869453]

There are 11 access points in the system. The distance between them is 80 mt. only the difference between 3 of them 450 mt. 2.4 MHz. Signals between operating devices are low. The current frequency settings are as shown in the picture. how the settings should be.

[marce1000]

 - Don't know why you are using Custom for Rf Channel Assignment and Tx Power Level Assignment - use Global.

 M.

[alikoca869453]

When global, the signal is low.

I want to learn, antenna gain dbi  and  

I want to learn, antenna gain dbi

---

[Leo Laohoo]

Why are the channel and power settings statically assigned?
Is ED-RRM enabled?

[alikoca869453]

Thanks for answer

This is done because the signal levels of the devices running 2.4 MHz are low.

What is your suggestion?

What is ED-RRM? how we should make this setting ?

[Leo Laohoo]

---

@alikoca869453 wrote:

This is done because the signal levels of the devices running 2.4 MHz are low.

---

My recommendation is to set the AP's channel selection and power selection to auto. 

Go to RRM and DCA and make sure they are set to auto.

[alikoca869453]

hi 

What should be the antenna gain setting?

[alikoca869453]

Hi

As you say, when I want to change the frequencies in the dca channel list section gives the following error.

[alikoca869453]

Hi

dca screen is as follows. What are your suggestions

[Leo Laohoo]

What AP do you have? Why are you adjusting the antenna gain?
What exactly are you trying to do?

[alikoca869453]

What AP do you have?              AIR-AP1562E-E-K9

Why are you adjusting the antenna gain?            Signal levels come low for 2.4mghz devices

exactly what I want to do is to raise the signal levels of the devices and ensure that they do not break.

a value must be entered here.
What is your suggestion.

[Leo Laohoo]

Ok, so if you have a 1562E what model of antenna are you using?

[alikoca869453]

AIR-ANT2513P4M-N 13 dbi  (There are 2 units and there is a distance of 800 meters between them.)

AIR-ANT2568VG-N 8 dbi    ( There are 8 units and there is a distance of 50 meters between them.

[Vasco Costa]

Have you done any site survey?
How are you measuring the signals provided by the antennas?