cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
113
Views
0
Helpful
3
Replies
Highlighted
Beginner

2602I stand alone to LWAP conversion

Is it possible to convert  AIR-SAP2602I to LWAP? I want to connect it to the WLC 5508 via flex ctonnect mode. What all are the LWAP models supported by the WLC 5508. I couldn't find these details in 5508 data sheet

1 ACCEPTED SOLUTION

Accepted Solutions
Highlighted
VIP Mentor

Yes it is possible to convert to LAP.

Here is the procedure to convert:

http://rscciew.wordpress.com/2014/05/07/access-point-conversion-lap-to-aap-and-vice-versa/

You can check here about flexconnect feature matrix:

http://www.cisco.com/c/en/us/support/docs/wireless/5500-series-wireless-controllers/112042-technote-product-00.html

 

Which AP supported by WLC depends on software version.

check thsi compatibilty matrix for support AP :

http://www.cisco.com/c/en/us/td/docs/wireless/compatibility/matrix/compatibility-matrix.html

 

Hope it helps.

Regards

Dont forget to rate helpful posts

View solution in original post

3 REPLIES 3
Highlighted
VIP Mentor

Yes it is possible to convert to LAP.

Here is the procedure to convert:

http://rscciew.wordpress.com/2014/05/07/access-point-conversion-lap-to-aap-and-vice-versa/

You can check here about flexconnect feature matrix:

http://www.cisco.com/c/en/us/support/docs/wireless/5500-series-wireless-controllers/112042-technote-product-00.html

 

Which AP supported by WLC depends on software version.

check thsi compatibilty matrix for support AP :

http://www.cisco.com/c/en/us/td/docs/wireless/compatibility/matrix/compatibility-matrix.html

 

Hope it helps.

Regards

Dont forget to rate helpful posts

View solution in original post

Highlighted
Enthusiast

just to more links for converting AP from stand alone to LWAP

http://targetcisco.blogspot.com/2011/01/converting-autonomous-access-point-to.html

Highlighted
Beginner

Thanks a lot Sandeep