09-06-2009 07:45 AM - edited 07-03-2021 06:01 PM
Hello,
Does anyone have a 5508 controller with 1142's setup in H-Reap mode with wpa2/aes/psk authentication?
No matter what configuration i try I cannot get a client connected if the access point is communicating with the controller. As soon as I disable/block the access point from communicating with the controller, the client can connect.
Has anyone else come across this problem? Could anyone else verify the same thing I have?
Thanks,
Dan.
09-11-2009 08:55 AM
An 1142 access point in hybrid-REAP mode sometimes enters stand-alone mode. If the access point is rebooted while in stand-alone mode, the 802.11a radio changes to a different channel than the one configured by the controller after a few minutes.
09-12-2009 08:10 AM
Very odd problem, but after i restarted the controller everything started working as it should.
Dan.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: