If there is nothing installed in port 1, the board will be configured for 10 G mode by default. Therefore, to switch to 1 G mode, an SFP module must be installed in port 1 and the system needs to be rebooted.
Conversely, if an SFP module is installed and the user wants to switch to 4 x 10 G mode, then an SFP+ module must be installed in port 1 and the WLC rebooted.
Thus, Online Insertion and Removal (OIR) of SFP and SFP+ between 10 G and 1 G is not possible.
After adding a WLC to ISE if you get the following error (See message below) after running debug aaa tacacs enable in the WLC. Incorrectly formatted authorization message Here's what you need to do to fix it. Login to ISE Work centers, Settings, Device ad...
Community Live- Understanding How Multicast Works with Cisco Wireless LAN Controllers
(Live event - formerly known as Webcast- Tuesday November 19, 2019 at 9 am Pacific/ 12 pm Eastern / 6 pm Paris)
This event will have place on Tuesday 19th, Novembe...
Where to download
Attached files on this post
Alternatively, cloud version (only summaries)
New implementation for the WLC Config Analyzer. it is a new re-write of the application, with clean up and improved checks
Support for IOS...
New Version for the Wireless Lan Config Analyzer: v.4.4.14
Supports AireOS up to 8.8, any model.
Error parsing AP list with location with spaces
For tool information: