04-04-2011 08:44 AM - edited 07-03-2021 08:02 PM
I want to upgrade my wireless controller (WISM) to 6.0.19x.0.
My question is does controller software version 6.0.188.0 and1242 and 1231 AP's
support the access point predownload process?
Solved! Go to Solution.
04-04-2011 10:17 AM
Hi,
I am Sorry,.. discard my previous post.. thats for another post!! By mistake i pasted der!!
here is the answer for urs..
If the pre download is used then it will apply only to the supported APs not for un supported!! SO u can use it but it gets applied only to 1240 series APs!!
lemme know if this answered ur question!!
Regards
Surendra
04-04-2011 09:55 AM
Hi,
From the Configuration guide 6.0 , we have the pre download available.. so this is supported.. However not on the AP 1230 series.. (not supported on 1230)
here is the link..
http://www.cisco.com/en/US/docs/wireless/controller/6.0/configuration/guide/c60mfw.html#wp1132291
Lemme know if this answered ur question!!
Regards
Surendra
04-04-2011 10:04 AM
Thanks for answering the question.
Do you know, since I have a mixed campus of 1231's and 1242's
Could I use the predownload on the 1242's or is it an
all or nothing on the controller?
04-04-2011 10:14 AM
Hi,
the below link will give u more info on assigning the IP to the LWAPP AP..
To enable LAG on the WLC, Open the WLC GUI and Monitor >> Controller >> General >> LAG >> Enable >> Reboot.
Lemme know if this answered ur question!!
Regards
Surendra
04-04-2011 10:17 AM
Hi,
I am Sorry,.. discard my previous post.. thats for another post!! By mistake i pasted der!!
here is the answer for urs..
If the pre download is used then it will apply only to the supported APs not for un supported!! SO u can use it but it gets applied only to 1240 series APs!!
lemme know if this answered ur question!!
Regards
Surendra
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide