Access Point Web Interface Makes Repeated Radius Requests, but SSH just one

[nathgregory]

Whenever I use the web browser for 2700 autonomous AP, it constantly makes radius requests, as can be seen in attached picture showing Cisco ISE radius logs.

If I access through SSH I just get one radius request and that is fine.

On the browser it is a massive amount, whether I use Chrome or IE.

Why might this be?

On Cisco ISE I have already supressed failed and successful from the logs.
TCPDump confirms only one request made.

[patoberli]

Well possible for session reasons. Don't use the GUI, only SSH :)
Maybe a software update might help, but I doubt it.

[nathgregory]

I think you're right, it just seems very excessive, there can be 15-20 requests showing in the logs all within the same second.

I use SSH normally, just easier to monitor associations on three separate APs in an easy to view way through the GUI.

Thankyou.