ACS 5.2, cant establish SSH

[MICHAEL SCHROEDER]

Hi All,

i try to Access ACS5.2 installed on VM via SSH. I used 3 different SSH Clients, Teraterm, Sec CRT and Putty, all failed. Putty failed after (correct) password, Teraterm and SCRT failed with a Popup and the List of ACS Supported Modes (DH Group 14, AESxxxCBC ...). I configured them in the Options, but failed again. Very frustrating...

Any Help Welcome.

Regards, Michael

[Scott Fella · Accepted solution]

Is this a new install? Can you look at the VM console and is all the services running. Is it just with ssh or can you https to ACS?

Sent from Cisco Technical Support iPhone App

[MICHAEL SCHROEDER]

Thanx Scott, since the Engine was very Fresh i recovered it. Regards, Michael

[Vinay Sharma]

Michael,

Could you please mark this question as answerd since the issue is resolved?

thanks,

Vinay

[rsrikant]

May i know how it got resolved.

I am facing the same problem. I not able to SSH to my ACS 5.2

It prompts me for the username & password. It is not accepting the credentials.