Anyconnect NAM shows " Limited or no connectivity" warning
In our deployment, few of the users are getting "Limited or No connectivity" warning in anyconnect NAM. Though there is no impact on his connectivity, the user gets proper IP address and he is able to ping his gateway from his system. But this warning is confusing the user about their connection. We have tried all possible steps as below:
1. Ensured Wired AutoConfig service is stopped for smooth working of Anyconnect NAM.
2. Updated the driver version.
3.Changed the Intel driver property of 802.11 n/ac Wireless mode to 802.11 n. It removed the warning for some time, but user again got it other day.
Attaching the DART bundle from one of the user's machine and the screenshots. Can someone please help if they have come with this issue.
[ The link to the discussion will be published on November 10th ]
This event is an opportunity to discuss the LTE market trends from a consumer perspective, highlighting the 4G LTE service from Cisco Enterprise BU. Furthermore, we will discuss the strateg...
Hi All,We have 9100 AP trying to join on 9800 WLC. When AP try to join controller it gives below error Sending Join request to 172.16.31.66 through port 5254Discarding msg CAPWAP_WTP_EVENT_REQUEST(type 9) in CAPWAP state: Join(5)Discarding msg CAPWAP...
Hello, I hope somebody has a solution for the issue I am facing. I have 2 WAP150's, both with firmware 18.104.22.168, and I am not able to save a specific change. Under Wireless > Radio > Advanced Settings > Legacy Rate Sets I can unselect ra...
Hey Guys,I Have several 1600 Series AP's (AIR-CAP1602I-ZK9) that was working with WLC before, I changed them with 1800 series but would like to use 1600 Access Points series independently and without WLC for somewhere else, so I want to know do they...