I wanted to check how other do this in their networks.
We are setting up a new wireless network and need to authenticated the APs as they are connected to the network using EAP-FAST. The network has been configured in closed mode using ISE.
The EAP-FAST settings will be applied to the WLCs so the question is how do we allow the APs to reach the WLCs in the first place to be able to retrieve the EAP-FAST setting/credentials? Do we need to seed the APs first on an open port or is there a better way of doing this?
QuestionI have the following Air AP:Air-AP1562I-B-K9, 802.11ac outdoor access point There are three antenna cables that go from the inside cover to some soldered connections on a PCB. When removing the cover, two of the soldered antenna connections c...
QuestionHiWe have a guest access set up and was wondering what exactly are the sequence of events from connecting to SSID to being granted internet access, see below steps I'm unsure of are left blank1. connect o SSID through AP2. traffic hits Foreign WLC...