Cisco 4400 Series 4400 wireless lan controller, Factory defaults
I need help with erasing the above unit i have a cisco rolled cable attached to the back of the laptop in the serial port, but i also have a serial Console port on the wireless lan controller as well how do i go about configuring the unit to factory defaults.
You need to connect the serial connector to your laptop and the other connector (RJ 45 connector) to the device then reboot your device. When it boots it will tell you to press escape to skip normal boot. If you do that you will get the reset to fefaults option on the list.
Sent from Cisco Technical Support iPad App
Rating useful replies is more useful than saying "Thank you"
Hi, My customer wants to Download a report of users with MAC addresses who logged in June 2020. He is using PRTG but that Server is not connected with WLC. What we need to do to achieve this goal? Thanks in advance. Regards,Waqas
[ The link to the discussion will be published on November 10th ]
This event is an opportunity to discuss the LTE market trends from a consumer perspective, highlighting the 4G LTE service from Cisco Enterprise BU. Furthermore, we will discuss the strateg...
Hi All,We have 9100 AP trying to join on 9800 WLC. When AP try to join controller it gives below error Sending Join request to 172.16.31.66 through port 5254Discarding msg CAPWAP_WTP_EVENT_REQUEST(type 9) in CAPWAP state: Join(5)Discarding msg CAPWAP...
Hello, I hope somebody has a solution for the issue I am facing. I have 2 WAP150's, both with firmware 220.127.116.11, and I am not able to save a specific change. Under Wireless > Radio > Advanced Settings > Legacy Rate Sets I can unselect ra...