cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
202
Views
0
Helpful
6
Replies
Beginner

Cisco AP 702W EAP TLS

Hello,

 

does anyone know which TLS version works with the Cisco Aironet 702W Access Point? 

 

Thanks for the replys.

6 REPLIES 6
Highlighted
VIP Collaborator

Re: Cisco AP 702W EAP TLS

 

 Ref : https://www.cisco.com/c/en/us/products/collateral/wireless/aironet-700-series/data_sheet_c78-728968.html

 

◦ Extensible Authentication Protocol-Transport Layer Security (EAP-TLS)

◦ EAP-Tunneled TLS (TTLS) or Microsoft Challenge Handshake Authentication Protocol Version 2 (MSCHAPv2)

>...

 M.

Highlighted
Beginner

Re: Cisco AP 702W EAP TLS

Hi marce,

thanks for the reply, but I want to know the TLS version which is supported by this AP. Is it TLS 1.1, 1.2 or 1.3?

 

 

Highlighted
VIP Advocate

Re: Cisco AP 702W EAP TLS

I think that depends what you exactly want to use. I think the Radius server is actually more important in that regard and the client. As far as I remember, the client only talks in TLS to the Radius server and that part is transparent for the AP. So the question is what your Radius and your Client supports.
Highlighted
Beginner

Re: Cisco AP 702W EAP TLS

The ISE we use only accepts TLS 1.2 and TLS 1.3. As soon as the AP tries to connect to the network the ISE shows that the connection is refused because TLS 1.0 or 1.1 is used by the AP. 

 

Is it possible to configure in the CLI of the AP the TLS version?

Highlighted
VIP Advocate

Re: Cisco AP 702W EAP TLS

Not that I know of, no. I'm pretty sure you need to enable TLS 1.0 to get EAP-TLS to work.


Highlighted
VIP Collaborator

Re: Cisco AP 702W EAP TLS

 

 - The latter may not be possible but also make sure that the current software version being used on the AP is no too old. If it would be , then upgrade to the most recent release and verify the problem again.

 M.

CreatePlease to create content
Content for Community-Ad

August's Community Spotlight Awards