Cisco ISE log configuration commands enetered on routers

[Bogdan Nita]

Hello,

I am trying to migrate from Cisco ACS to ISE.
I want to log configuration commands entered on routers.
I have configured the routers to send accounting radius to ISE but ISE sees the messages as:

"22003  Missing attribute for authentication
11014  RADIUS packet contains invalid attribute(s)"

Can I configure ISE to receive radius accounting messages ?

Is there another way to configure ISE to log configuration commands ?

Another way would be to send syslog messages, but does ISE receive syslog ?

Regards,

Bogdan

[Scott Fella]

You should post your question on the AAA forum

https://supportforums.cisco.com/community/netpro/security/aaa

Thanks,

Scott

Help out other by using the rating system and marking answered questions as "Answered"

[Bogdan Nita]

Thank you Scott.

I followed your advice.