cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
430
Views
0
Helpful
3
Replies
Highlighted
Beginner

Cisco Prime 1.2 - same WLANID accross all controllers

Hi,

does anyone know how to achieve to have same WLAN IDs accross all controllers using a WLC Template?

There is no possibility to enter the ID directly.

When I create a WLAN with the same name on WLC before it's not being overwritten and SNMP to device fails.

Thanks for any hints.

K.

Everyone's tags (5)
3 REPLIES 3
Cisco Employee

Cisco Prime 1.2 - same WLANID accross all controllers

Hello,

You can use a CLI template from PI 1.2. It would be the same procedure/commands as configuring the WLAN from the CLI of the controller but using PI to keep them uniform across the WLC's.

It can be found from Design --> Configuration templates --> Controller --> CLI --> General.

Ram

Beginner

Cisco Prime 1.2 - same WLANID accross all controllers

Yes, that's can be also the way, but here I have worries if it will also work for older 4404 WLCs.

However I would welcome if the wlan ID could be added to the PI templates.

K.

Beginner

Cisco Prime 1.2 - same WLANID accross all controllers

I would also like to see the capability to specify the WLAN ID without having to resort to a CLI configuration template.

CreatePlease to create content
Content for Community-Ad
August's Community Spotlight Awards