Cisco Prime Infrastructure 1.2.1 - Factory Reset gone?

[croos]

Hi there,

does anybody now how to do an application reset/factory reset on Prime Infrastructure 1.2.1? It seems the previously known commands are not working anymore:

/admin# application reset-config NCS

This command is not supported in the current version of the application.

ncs db reinit is unfortuantely not enough. We tried to initiate the corresponding scripts from /opt/CSCOlumos/bin but not success so far.

VM deployment on XEN is very slow and i would like to avoid to wait 6 hours again for the large VAPPL to be ready.

Thanks a lot in advance

Cheers

Christian

[Scott Fella]

Yes it is gone.... So a new install is required.

Thanks,

Scott

Help out other by using the rating system and marking answered questions as "Answered"