cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

Community Helping Community

777
Views
0
Helpful
3
Replies
Beginner

Cisco WLC 5520 adder license question

Greetings:

We have 47 sites using a pair of 5520 SSO for FlexConnect. When I add my new RTU 3 Ap license for a small branch the message returned by the WLC said reboot required. Can I ignore this? It’s an operation nightmare to reboot, requires change management and service disruption notices. I thought I read somewhere reboot not required.

 

3 REPLIES 3
VIP Advisor

Re: Cisco WLC 5520 adder license question

that´s correct. We can see this on Cisco doc. For RTU they dont ask to reboot, but 

 

now.JPG

Before it was requested.

 

before.JPG

 

 

Highlighted
Beginner

Re: Cisco WLC 5520 adder license question

Hi Robert,

Just wondering how the AP adder turned out. I am in a similar situation. Cisco doc says just save config but after hitting the set count button..a message popped up that reboot is necessary. if you did reboot,since its in HA, am guessing you had to reboot both controller one time. Appreciate your feedback in advance.

 

AB

Hall of Fame Master

Re: Cisco WLC 5520 adder license question

You can always just issue a force switchover on the primary and then wait for the primary to come up and sync. Then issue a force switchover again so that your primary becomes active.
-Scott
*** Please rate helpful posts ***
CreatePlease to create content
Content for Community-Ad

August's Community Spotlight Awards