cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
3545
Views
9
Helpful
3
Replies
Highlighted
Contributor

CLI Commands for AP in FlexConnect

Hi Everyone, 

Just as the title said, as much as I googled this one I cannot seem to find it what are the CLI Commands for AP in FlexConnect

I know we can telnet/ssh to the AP in flexConnect but what are the possible commands we can execute on the AP?
Hope someone can assist :D 

Thanks!
 

Everyone's tags (5)
1 ACCEPTED SOLUTION

Accepted Solutions
VIP Mentor

This may be useful if you

This may be useful if you haven't see it 

http://www.cisco.com/en/US/docs/wireless/controller/7.4/command/reference/flexconnect/flexconnectcr74.pdf

HTH

Rasika

*** Pls rate all useful responses ***

3 REPLIES 3
Rising star

Hi LJ, With FlexConnect APs

Hi LJ,

 

With FlexConnect APs they should be managed by the WLAN Controller they are associated to and therefore local commands aren't recommended besides some basic ones if necessary e.g. setting the Controller IP address for discovery and running debug commands. You do have the ability to run many of the CLI commands on there but you shouldn't.

Cheers,
Ric

-----------------------------
Please rate helpful / correct posts
Contributor

Well figuresProbably the only

Well figures
Probably the only thing you can do on that side is the basic "capwap ap" commands e.g., assigning its IP and WLC controller IP

Telnet/SSH useful only if ever we need to change the TCP/IP settings of the AP in w/c the local IT for example, has no console cable and needs to telnet/SSH to it

VIP Mentor

This may be useful if you

This may be useful if you haven't see it 

http://www.cisco.com/en/US/docs/wireless/controller/7.4/command/reference/flexconnect/flexconnectcr74.pdf

HTH

Rasika

*** Pls rate all useful responses ***

CreatePlease to create content
Content for Community-Ad
August's Community Spotlight Awards