Command for association and disassociation between APs and Bridge mode.

[Rafael Santos]

Hello,

I have an AP AIR-BR1310G-A-K9 model and when I do the "show dot11 associations" command I can see the other APs associated with it that is in Bridge mode.

I would like to know what command I can execute on my AP in Bridge mode to force a disassociation and then force a new association between the bridge and the other AP.

Thanks in advance.

Rafael Santos

[johnd2310 · Accepted solution]

Hi,

Have you tried the following command:

clear dot11 client H.H.H

where H.H.H is the mac address of the client

Thanks

John

[Haydn Andrews]

To remove a client association use:

clear dot11 client <Mac address in format of 0011.2233.4455>  

it will deauthenticate the client

Or you can use:

clear int dot11radio0/ dot11radio1 

to reset the radio

Useful autonomous CLI commands here:

http://www.my80211.com/cisco-auton-cli-commands/