cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
616
Views
0
Helpful
4
Replies
Highlighted
Beginner

Config network broadcast

Hello,

I know that I can enable Broadcast in the WLC using CLI( config network broadcast enable ). Can I do it in the Web Interface?

Regards.

1 ACCEPTED SOLUTION

Accepted Solutions
VIP Mentor

Re: Config network broadcast

HI,

Ok now I got ur point.

Here is the GUI Procedure to do it .

Controller > General > enable the Broadcasting forwarding


Here is the screenshot:

untitled.bmp

Regards

DONt forget to rate helpful posts

4 REPLIES 4
VIP Mentor

Config network broadcast

yes you can do it .

Login to WLC GUI.

WLAN > Click on WLAN ID > General > then check the box for broadcast.

Regards

Dont forget to rate helpful posts

Beginner

Config network broadcast

I think that you don't understand my question.

The answer you give me corresponds to the following command:

config wlan broadcast-ssid enable

The command that I'm referring to is :

config network broadcast enable

Regards

VIP Mentor

Re: Config network broadcast

HI,

Ok now I got ur point.

Here is the GUI Procedure to do it .

Controller > General > enable the Broadcasting forwarding


Here is the screenshot:

untitled.bmp

Regards

DONt forget to rate helpful posts

Beginner

Config network broadcast

Correct Answer

Thank you!

CreatePlease to create content
Content for Community-Ad
August's Community Spotlight Awards