Config network broadcast

[Felipe Agudo]

Hello,

I know that I can enable Broadcast in the WLC using CLI( config network broadcast enable ). Can I do it in the Web Interface?

Regards.

[Sandeep Choudhary]

yes you can do it .

Login to WLC GUI.

WLAN > Click on WLAN ID > General > then check the box for broadcast.

Regards

Dont forget to rate helpful posts

[Felipe Agudo]

I think that you don't understand my question.

The answer you give me corresponds to the following command:

config wlan broadcast-ssid enable

The command that I'm referring to is :

config network broadcast enable

Regards

[Sandeep Choudhary · Accepted solution]

HI,

Ok now I got ur point.

Here is the GUI Procedure to do it .

Controller > General > enable the Broadcasting forwarding

Here is the screenshot:

Regards

DONt forget to rate helpful posts

[Felipe Agudo]

Correct Answer

Thank you!