12-14-2011 07:42 AM - edited 07-03-2021 09:14 PM
Hi ALL,
In our setup we have WiSM modules installed on cisco 6506-E, ACS 5.3 virtual appliance.
We are trying to implement EAP-FAST for our Wireless using WPA/WPA2 802.1x on the WLC side.
I have followed the instructions in the following document step-by-step:
https://supportforums.cisco.com/docs/DOC-15587
Still I have no success. Tried most of the permutations on ACS EAP-FAST configuration.
I recieve the following error in acs:
Appreciate your help.
Regards
Ramakrishnan Natarajan
12-15-2011 08:20 AM
what supplicant are you using on the laptop? It looks like it is sending the username anonymous, instead of a valid username.
HTH,
Steve
----------------------------------------------------------------------------------------------------------
Please remember to rate helpful posts or to mark the question as answered so that it can be found later.
12-17-2011 01:35 PM
can you run debugs on the controller to see whats being sent to the radius and whats coming back?
> debug client
> debug aaa events enable
Also, check how the profile has been setup on the laptop
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: