01-13-2019 02:36 PM - edited 07-05-2021 09:41 AM
I manually disabled a client in the monitor>clients and when I check in the WLC's CLI the client is excluded. Now I can't find a way to enable the client using either CLI or GUI.
01-13-2019 02:41 PM
After testing different command in CLI I found the command which is (Cisco Controller) >config exclusionlist delete < MAC add >
but still I don't know how to do it through GUI
01-13-2019 03:30 PM
Hi,
If you manually disabled the client, you can re-enable by going to Monitor -> Disabled Clients(Detail) and click remove on the blue down arrow.
Thanks
John
01-13-2019 08:00 PM
I got it. It was hidden at the bottom of the page.
Thank you
Regards
John P
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide