cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
421
Views
0
Helpful
2
Replies

encrypted (DTLS)

skelley5000
Level 1
Level 1

I have a T1 connection to one of my sites, I am running HREAP with 4 AP's. I have been noticing a spike in traffic from my AP's to the WLC. Even when no one is on the wireless. Does anyone know when you use encryption (DTLS) should this cause spikes on the T1? I don't notice it anywhere else.

Thanks

2 Replies 2

Scott Fella
Hall of Fame
Hall of Fame

It does add overhead. But you would just have to monitor it. Baseline the traffic with dtls disabled and see for yourself the difference.

Sent from Cisco Technical Support iPhone App

-Scott
*** Please rate helpful posts ***

Saravanan Lakshmanan
Cisco Employee
Cisco Employee

#Enable link latency feature for this access point.

http://www.cisco.com/en/US/docs/wireless/controller/7.2/configuration/guide/cg_lwap.html#wp1344052

what model AP are you using?

#In a Cisco unified local wireless network environment, do not enable DTLS on the Cisco 1130 and 1240 access points, as it may result in severe throughput degradation and may render the APs unusable.

http://www.cisco.com/en/US/products/ps10315/products_tech_note09186a0080b3690b.shtml

#Remove centrally switched wlan from hreap AP, that'll disble data DTLS.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: