but it only boots the bootloader, and thats about it.
i have tried the resetbutton, but i only get the secs showed that i have pressed the button, so im guessing that the software is gone from the controller, also because it 'boots up' with 'bash-3.2#'
im new to using controllers, so any help would be appeciated.
this is the only output i seem to get:
bash-3.2# help GNU bash, version 3.2.25(1)-release (i686-redhat-linux-gnu) These shell commands are defined internally. Type `help' to see this list. Type `help name' to find out more about the function `name'. Use `info bash' to find out more about the shell in general. Use `man -k' or `info' to find out more about commands not in this list.
i do have the software 'AIR-WLC520-K9-5-2-193-0.aes' but i dont know how to get into an 'iOS-like' environment. because when it gets an ip, and somewhat command line input ill guess ill manage then.
i even have used the 'Interactive setup' that pops-up during boot, but option 3 & 5 seem to stall everything. because im not represented further with an option, and the screen stays blank.
and what seems wrong to me, is that my 'SN:' field is empty?
Model 3500 S/N:
Booting Primary Image...
Press <ESC> now for additional boot options...
Please choose an option from below:
1. Run primary image (Version ) (active) 2. Run backup image (Version ) 3. Manually upgrade primary image 4. Change active boot image 5. Clear Configuration
Please enter your choice: 3
if you need more info, or anything, just let me know, and ill get it for you.
We want to broadcast a SSID (and allow users to connect) between certain times each day, and then take it offline. Unfortunately we dont have prime and only DNA Essential Smart licencing. All documents that I am seeing is that its possible if you have pri...
Hi all,I am looking for some guidance here, and I am quite certain that some of you, great minds, will be able to stir me in the right direction here. And a big thanks in advance. Here we go, i have three sites connected over private link MPLS....
Hi to all I purchase new AP C9120AXE converted to EWC.I notice when AP is booting a message related to default route not set that it says that can affect performance.Message is : %Default route without gateway, if not a point-to-point interface,...
Hi all, I am trying to convert AIR-AP2802I-B-K9 from CAPWAP to ME using this guide https://www.cisco.com/c/en/us/td/docs/wireless/access_point/mob_exp/1/user_guide/b_ME_User_Guide/getg_start.html#task_7588F4C009744AEFBB9EB754A713E390 I...
Hi All, Currently i have a 9800-cl wlc with 2700, 3800 and 9100 series access points (internal APs). All three APs broadcast same SSID with (WPA2/PSK) for come legacy clients which operates on 802.11b. Also I'm using the same RF, site and p...