cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
282
Views
0
Helpful
2
Replies
Highlighted
Beginner

Flexconnect AP ACLs

I need some help in understanding where the ACL is being applied on a flexconnect access point in local switching mode.

I am assuming that the ingress ACL is being applied between the wireless client and the access point over the air on the traffic that is being received by the access point and the egress ACL is being applied at the wire between the access point and the switch as the traffic leaves the access point. Is this correct or am I thinking about this all wrong?

 

 

 

2 REPLIES 2
Highlighted
VIP Advocate

 

- Check if this thread can provide some insights :

           https://community.cisco.com/t5/network-access-control/airespace-acl-flexconnect-ap/td-p/3730611

 M.

Highlighted
Beginner

Thanks for the quick reply but this is not exactly what I am trying to get an understanding on. I am trying to determine where the flexconnect ACL is being applied and what direction it is being applied in.