How tag management vlan for wlc via cli

[syed baseeruddin]

Hi

There are two controller and core switch

in core i will create vlan 94

int vl94

ip addd

 and int g1/1

switchport mode trunk

in the wlc

Interface Name Port Vlan Id IP Address Type Ap Mgr Guest
-------------------------------- ---- -------- --------------- ------- ------ -----
management 1 94 192.168.50.252 Static Yes N/A
redundancy-management 1 94 0.0.0.0 Static No N/A

i had made at installation 0:untagged=94

i assume that my management vlan is tagged

i am confusion these tagging of management vlan 

experts please advice 

as i am not able to ping the controller 

[Flavio Miranda · Accepted solution]

Hi

   Leave Management untagged and enable LAG.

config interface vlan management 0

-If I helped you somehow, please, rate it as useful.-

[syed baseeruddin]

Thanks,

i need understand

config interface vlan management 0

for my network side for example i am using vlan 94

config interface vlan management 94 ip add 192.168.50.250 255.255.255.0 192.168.50.254

please correct me if am wrong

[syed baseeruddin]

Thanks

one more thing clear i will LAG

at that had made at installation 0:untagged=0 or i need vlan number

got confussion 

please advice

[Flavio Miranda]

 Vlan = 0  means all vlan permitted.  LAG is just like trunk on switch side.

-If I helped you somehow, please, rate it as useful.-

[Rasika Nayanajith]

if you set to 0, that mean management interface traffic is not tagged at WLC . That mean management vlan should be native vlan across your trunk, in that way switch side as well not tagging that vlan traffic.

If you set it to 94, that mean controller will add vlan 94 tag for traffic on that interface. So that to work, you need to ensure vlan 94 is not native vlan on that trunk link.

HTH

Rasika

*** Pls rate all useful responses ***