08-22-2019 01:16 PM - edited 07-05-2021 10:53 AM
Hi everybody;
I have the following question, i just installed and configured WLC controller with 7 AP's, the management interface have the ip address 192.168.10.90. i am able to ping the interface vlan 10 (internally is the management vlan) of switch 1 (192.168.10.22) and even i am able to ping from WLC whatever ip address from managament vlan of all of devices of my network. I tried to ping my radius server 10.102.100.1 too, but in this case i am not be able to.
On switch 1 i can ping the radius ip address 10.102.100.1 , and also i tried ping 10.102.100.1 source 192.168.10.22 and i can ping.
What could it be the problem??
08-22-2019 02:31 PM
On the ME AP, do you have default-gateway setting point it to your SW IP (10.22) ?
HTH
Rasika
08-22-2019 11:27 PM
08-23-2019 01:16 AM - edited 08-23-2019 01:18 AM
That's look normal.
What happen if you put a PC on vlan 10 & see if you can ping RADIUS server from that PC ?
To double check, pls share your switchport configuration that connects to ME
Rasika
08-23-2019 03:23 AM
09-24-2019 06:44 AM
I still having the problem, could you help me? :(
09-24-2019 06:55 AM
09-24-2019 07:40 AM
09-24-2019 08:25 AM
09-25-2019 12:28 AM
09-25-2019 02:29 AM
It depends on your setup, but essentially yes try this for testing.
10-30-2020 06:24 AM
Hi pozoteleco,
I am having the same issue, so how do you fix it?
Thanks
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: