At present we have a dual stack network on a wired FLAT LAN (the WLAN shares the same Subnet/VLAN). Developers use IPv6 on the LAN mostly for testing, but at present must patch into a wired Ethernet port to use it. It would be handy for them to utilize the IPv6 network while on the WLAN.
The wireless is a single AP running the MEC software and acting as the office AP /Controller
What configuration changes must I make to allow IPv6 on the WLAN? Should it work by default?
Is there a way to enable it in the GUI? Or, must I enable in CLI?
I have:Product/Model Number : AIR-SAP1602I-E-K9withCisco IOS Software, C1600 Software (AP1G2-K9W7-M), Version 15.3(3)JC, RELEASE SOFTWARE (fc1)I need to have internet access via eth in a deep place of my basement. So I bought a small thing called wifi ext...
I have a few AIR-CAP3502E-A-K9 access points that I want to change to Lightweight mode. I did a lot of researching and found that I needed the ap3g1-k9w7-tar.153-3.JAB.tar file or a similar version of it.I do have that file and I was able to upload ...
WLAN Poller provides functionality to:
Bulk data/debug collection from Controllers and APs. Execute the commands on regular intervals.
DFS statistics and debug collection
IOS AP Flash health check and memory
AP cert check with generating reports
My report tells you a simple viewpoint to understand the evolution of the wireless LAN from 1997 to the 2020s. You can also get basic knowledge on an uplink of Wi-Fi6, the latest IEEE 802.11ax standard. Data analysis results based on our experimental s...