cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

157
Views
5
Helpful
1
Replies
Beginner

IPv6 for wifi Clients

Hi,

 

I would like to enable IPv6 for an office WLAN.

 

At present we have a dual stack network on a wired FLAT LAN (the WLAN shares the same Subnet/VLAN). Developers use IPv6 on the LAN mostly for testing, but at present must patch into a wired Ethernet port to use it. It would be handy for them to utilize the IPv6 network while on the WLAN.

 

The wireless is a single AP running the MEC software and acting as the office AP /Controller

 

What configuration changes must I make to allow IPv6 on the WLAN? Should it work by default?

 

Is there a way to enable it in the GUI? Or, must I enable in CLI?

 

Thank you, Pat

1 ACCEPTED SOLUTION

Accepted Solutions
VIP Mentor

Re: IPv6 for wifi Clients

If it is a Mobility Express AP, pls follow below guide

https://www.cisco.com/c/en/us/td/docs/wireless/controller/8-5/config-guide/b_cg85/ipv6.html

 

HTH

Rasika

*** Pls rate all useful responses ***

1 REPLY 1
VIP Mentor

Re: IPv6 for wifi Clients

If it is a Mobility Express AP, pls follow below guide

https://www.cisco.com/c/en/us/td/docs/wireless/controller/8-5/config-guide/b_cg85/ipv6.html

 

HTH

Rasika

*** Pls rate all useful responses ***

CreatePlease to create content
Content for Community-Ad
August's Community Spotlight Awards