The probe request is nswered automatically by the AP, it basically depends on the signal strength. I am not sure but there are certain prameters that can be tuned so that certain P always answers a probe.
To configure IP Address in AP
config ap static-ip enable AP-NAME IP-ADDRESS MASK GATEWAY
To configure AP Credentials for Telnet/SSH
config ap telnet enable AP-NAME
config ap ssh enable AP-NAME
config ap mgmtuser add username USERNAME password PASSWORD en...
We are unable to see the radios APs available... we connect direct to to the POE 110SG-24 ptos switch but its star blinking as it is running and suddenly blinking form red-blue-green-off .. .as we read it means it doesnt have enough power... b...
I want to reserve IPs which are got from dhcp server. My dhcp server is configured in cisco WLC-2504.
I can reserve IPs by mac binding in cisco 3850 switch. What is the procedure for WLC-2504. (
I've already issued "config network ip-mac-bindi...