cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1540
Views
0
Helpful
18
Replies
Hall of Fame Master

lap1262n lap to autonomous

Change your subnet mask on your PC to 255.255.255.0 and no need for a default gateway.  Disable any firewall on your machine and then follow the previous instructions.  You don't need to change the ip address on the AP and now you willo need to erase and reboot.  So when you are in the CLI of the AP, issue a write erase and then reboot without saving.  When the ap comes back, make sure there is no static address set.  Then follow the proceedures above.

Thanks,

Scott

Help out other by using the rating system and marking answered questions as "Answered"

-Scott
*** Please rate helpful posts ***

View solution in original post

Highlighted
Participant

lap1262n lap to autonomous

Hello Driss,

This topic is a little confusing, I did the conversion many time ago and for not confusing you I recommed you to watch this youtube videos:

http://www.youtube.com/watch?v=wWDrFjwVNb0

http://www.youtube.com/watch?v=QQ_NuxdRhQ4

If it is useful please rate.

Best regards.

View solution in original post

Beginner

Re: lap1262n lap to autonomous

Hello

i was going via all the tools provided by our cloeagues and your tools as well but the main problem i cannot reach the interface of access point is something strange i never got is in my life

now the access hunging on the :

not sending discover request ap doesn't have an ip ..

thank you

Beginner

Re: lap1262n lap to autonomous

Hello Team ,

Thanks a lot for the support

when i investigate it''s firewall behind blocking the transfer of the ios / actually the Chinese youtoob solution was help full a lot

see you in the coming scenario

Driss

CreatePlease to create content
Content for Community-Ad
August's Community Spotlight Awards