Re: mac filtering and wpa2 enterprise with WLC and radius
If you are using PEAP authentication through ACS you can enter the MAC address under the "Per User Defined Network Access Restrictions" under the user setup page in ACS. Check "Define CLI/DNIS-based access restrictions" and permit port=*, CLI = "MAC address", DNIS = *.
QuestionI have the following Air AP:Air-AP1562I-B-K9, 802.11ac outdoor access point There are three antenna cables that go from the inside cover to some soldered connections on a PCB. When removing the cover, two of the soldered antenna connections c...
QuestionHiWe have a guest access set up and was wondering what exactly are the sequence of events from connecting to SSID to being granted internet access, see below steps I'm unsure of are left blank1. connect o SSID through AP2. traffic hits Foreign WLC...
Model:C9120AXI-Q Install EWC on C9120 running with CAPWAP as shown in the attached log, but the installation fails.It looks like you're getting an error like out of storage space.Is there any good way?