cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
136
Views
0
Helpful
1
Replies
Highlighted
Beginner

MESH works, but no ping to APs

 

Hello, I have a 2504 WLC controller. I have tested all the stable and intermediate versions of the controller software like (AIR-CT2500-K9-8-3-150-0.aes; AIR-CT2500-K9-8-5-140-0.aes ; AIR-CT2500-K9-8-5-151-0.aes, as well as their bundles). I have 7 APs (5 * 1572 (newer models) and 2 * 1552 (older model)). When I make MESH only from the new APs, everything works smoothly. When I add one of the older APs or two of them, the mesh and the client still work smoothly, but I lose a ping from the outside to the AP and lose the monitoring (from WLC I still can ping APs). These are the Global Telnet SSH options enabled, but when an old AP join the MESH, after 5-8 pings go trough I lose pings at the same time by all.

Please help me.

1 ACCEPTED SOLUTION

Accepted Solutions
Beginner

Re: MESH works, but no ping to APs

SOLEVED !!!

The ROOT AP must be connected on a router or switch, but it should not be direct connected to WLC and should be in the same VLAN as the WLC and everything works perfectly.

 

1 REPLY 1
Beginner

Re: MESH works, but no ping to APs

SOLEVED !!!

The ROOT AP must be connected on a router or switch, but it should not be direct connected to WLC and should be in the same VLAN as the WLC and everything works perfectly.

 

CreatePlease to create content
Content for Community-Ad
July's Community Spotlight Awards